Lowell 810 Speaker-8in Cone 10oz Magnet 15W 8 ohm

Write a Review

Ask a Question

Eight inch driver with 10 oz. magnet provides a step up in full range performance from the commercial industry standard (8 in. 5 oz. driver) for solid performance and value in paging or background music systems requiring clear communications.

PERFORMANCE

Background music and paging

FEATURES

• Description: Highly efficient magnetic structure energized by 10 oz. ceramic magnet with 3/4 in. hard fiber whizzer cone mechanically coupled to 1 in. voice coil for extended high frequency response with fine clarity. Molded fibre cone enhances mid and low-range frequency performance.

• Frame: Stamped 20-gauge steel with zinc-plated finish to prevent corrosion.

• Power Rating: 15W

• Frequency Response: 54Hz-11.6Hz (±6dB) and 50Hz-20kHz (±6.6dB)

• Mounting Depth: 2.84 in.

• Mounting Bolt Circle: 7.625 in.

• Dispersion Angle: 95 degrees conical

• Average Sensitivity: 97.9dB

COMPLIANCE & CERTIFICATION

• Made in U.S.A. with global components

• Meets or exceeds industry standards

The dual cone 8-inch speaker shall be Lowell Model No. 810 which shall be of the permanent magnet type having a seamless molded fiber cone with a hard fiber whizzer cone mechanically coupled to a voice coil for extended high frequency response. It shall be capable of producing a uniform audible frequency response over the range of 54Hz-11.6kHz (±6dB) and 50Hz-20kHz (±6.6dB) with dispersion angle of 95 degrees @2000Hz (-6dB). Average sensitivity shall measure 97.9dB (SPL at 1W/1M). Power rating shall be 15 watts RMS. The voice coil shall have a 1-in. dia. and shall operate in a magnetic field derived from a strontium ferrite (ceramic) magnet having a nominal weight of 10 oz. Voice coil impedance shall be 8ohms. The driver shall have a round, structurally reinforced stamped 20-gauge steel frame with 8.062" overall diameter and eight obround holes equally spaced at 45 degrees on a 7.625" dia. mounting bolt circle. Overall depth shall not exceed 2.84". External metal parts shall be zinc-plated to resist rust and corrosion.